D-Link xStack DGS-3420 Series - Enable Snmp Traps; Disable Snmp Traps

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
698
DGS-3420-28SC:admin#config snmp system_contact "MIS Department IV"
Command: config snmp system_contact "MIS Department IV"
Success.
DGS-3420-28SC:admin#
62-11 enable snmp traps
Description
This command is used to enable SNMP trap support on the switch.
Format
enable snmp traps
Parameters
None.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To enable SNMP trap support:
DGS-3420-28SC:admin#enable snmp traps
Command: enable snmp traps
Success.
DGS-3420-28SC:admin#
62-12 disable snmp traps
Description
This command is used to disable SNMP trap support on the switch.
Format
disable snmp traps