D-Link xStack DGS-3420 Series - Page 702

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
697
Format
config snmp system_location <sw_location>
Parameters
<sw_location> - Specify an SNMP system location for the switch. A maximum of 255 characters is
allowed.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To configure the switch location for “HQ 5F”:
DGS-3420-28SC:admin#config snmp system_location HQ 5F
Command: config snmp system_location HQ 5F
Success.
DGS-3420-28SC:admin#
62-10 config snmp system_contact
Description
This command is used to enter the name and/or other information to identify an SNMP system contact
person who is responsible for the switch. A maximum of 255 characters can be used.
Format
config snmp system_contact <sw_contact>
Parameters
<sw_contact> - Specify an SNMP system contact person. A maximum of 255 characters is allowed.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To configure the switch contact to “ MIS Department IV ”: