D-Link xStack DGS-3420 Series - Page 701

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
696
Management Stations
IP Address Access Interface
----------------------------------------------------------------------------
10.48.93.100
10.51.17.1
10.50.95.90
Total Entries : 3
DGS-3420-28SC:admin#
62-8 config snmp system_name
Description
This command is used to configure the SNMP system name of the switch.
Format
config snmp system_name <sw_name>
Parameters
<sw_name> - Specify an SNMP system name for the switch. A maximum of 255 characters is
allowed.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To configure the switch SNMP name for “DGS-3420-28SC Gigabit Ethernet Switch”:
DGS-3420-28SC:admin# config snmp system_name DGS-3420-28SC Gigabit Ethernet
Switch
Command: config snmp system_name DGS-3420-28SC Gigabit Ethernet Switch
Success.
DGS-3420-28SC:admin#
62-9 config snmp system_location
Description
This command is used to enter a description of the SNMP system location of the switch. A maximum
of 255 characters can be used.