D-Link xStack DGS-3420 Series - Chapter 12 Sflow Commands

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
850
Chapter 12 sFlow Commands
enable sflow
disable sflow
show sflow
create sflow flow_sampler ports [<portlist> | all] analyzer_server_id <value 1-4> {rate <value 0-
65535> | tx_rate <value 0-65535> | maxheadersize <value 18-256>}
config sflow flow_sampler ports [<portlist> | all] {rate <value 0-65535> | tx_rate <value 0-65535> |
maxheadersize <value 18-256>}(1)
delete sflow flow_sampler ports [<portlist> | all]
create sflow analyzer_server <value 1-4> owner<name 16> {timeout [<sec 1-2000000> | infinite] |
collectoraddress [<ipaddr> | <ipv6addr>] | collectorport <udp_port_number 1-65535> |
maxdatagramsize <value 300-1400>}
delete sflow analyzer_server <value 1-4>
config sflow analyzer_server <value 1-4> {timeout [<sec 1-2000000> | infinite] | collectoraddress
[<ipaddr> | <ipv6addr>] | collectorport <udp_port_number 1-65535> | maxdatagramsize <value
300-1400>}(1)
show sflow analyzer_server
create sflow counter_poller ports [<portlist> | all] analyzer_server_id <value 1-4> {interval [disable |
<sec 20-120>]}
config sflow counter_poller ports [<portlist> | all] interval [disable | <sec 20-120>]
delete sflow counter_poller ports [<portlist> | all]
show sflow counter_poller
show sflow flow_sampler
12-1 enable sflow
Description
This command is used to enable the sFlow function.
Format
enable sflow
Parameters
None.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To enable the sFlow function: