D-Link xStack DGS-3420 Series - Config Firmware Image

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
990
DGS-3420-28SC:admin#upload log_toRCP username rcp_user 172.18.212.104 dest_file
/home/DGS-3420.log
Command: upload log_toRCP username rcp_user 172.18.212.104 dest_file /home/DGS-
3420.log
Connecting to server................... Done.
Upload log............................. Done.
Success.
To upload log from the device to an RCP server using an RCP string:
DGS-3420-28SC:admin#upload log_toRCP rcp: tld2@172.18.212.104/home/DGS-3420.log
Command: upload log_toRCP rcp: tld2@172.18.212.104/home/DGS-3420.log
Connecting to server................... Done.
Upload log............................. Done.
Success.
DGS-3420-28SC:admin#
29-9 config firmware image
Description
This command is used to configure firmware as a boot-up image.
Format
config firmware image {unit <unit_id>} <pathname> boot_up
Parameters
unit – (Optional) Specifies the unit ID used for this configuration.
<unit_id> - Enter the unit ID used for this configuration here.
<pathname> - Specify a firmware on the device file system.
boot_up - Specify as a boot-up file.
Restrictions
Only Administrator-level users can issue this command.
Example
To configure a firmware file to bootup:
DGS-3420-28SC:admin#config firmware image 2.00.009.had boot_up