D-Link xStack DGS-3420 Series - Chapter 47 LACP Configuration Commands

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
557
Chapter 47 LACP Configuration
Commands
config lacp_port <portlist> mode [active | passive]
show lacp_port {<portlist>}
47-1 config lacp_port
Description
This command is used to configure per-port LACP mode.
Format
config lacp_port <portlist> mode [active | passive]
Parameters
<portlist> - Specify a range of ports to be configured.
mode – Specify the port mode.
active - Specify the mode as active.
passive - Specify the mode as passive.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure port LACP mode for ports 1 to 3:
DGS-3420-28SC:admin#config lacp_port 1-3 mode active
Command: config lacp_port 1-3 mode active
Success.
DGS-3420-28SC:admin#
47-2 show lacp_port
Description
This command is used to display per-port LACP mode.