D-Link xStack DGS-3420 Series User Manual

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
906
Parameters
None.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To disable STP:
DGS-3420-28SC:admin#disable stp
Command: disable stp
Success.
DGS-3420-28SC:admin#
16-11 config stp version
Description
This command is used to enable STP globally. If the version is configured as STP or RSTP, all
currently running MSTIs should be disabled. If the version is configured as MSTP, the current chip
design is enabled for all available MSTIs (assuming that CIST is enabled).
Format
config stp version [mstp | rstp | stp]
Parameters
mstp - Specify to use Multiple Spanning Tree Protocol.
rstp - Specify to use Rapid Spanning Tree Protocol. This is the default.
stp - Specify to use Spanning Tree Protocol.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure the STP version:
DGS-3420-28SC:admin#config stp version mstp
Command: config stp version mstp
Success.

D-Link xStack DGS-3420 Series Specifications

General

Brand	D-Link
Model	xStack DGS-3420 Series
Category	Switch
Language	English