xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
841
delete - (Optional) Specify to delete source ports.
ports - (Optional) Specify source port list to add to or delete from the RSPAN source.
<portlist> - Specify a range of ports to be configured.
rx - (Optional) Specify to only monitor ingress packets.
tx - (Optional) Specify to only monitor egress packets.
both - (Optional) Specify to monitor both ingress and egress packets.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To configure an RSPAN source entry without source target port:
DGS-3420-28SC:admin#config rspan vlan vlan_name vlan2 source add ports 2-5 rx
Command: config rspan vlan vlan_name vlan2 source add ports 2-5 rx
Success.
To configure an RSPAN source entry for per flow RSPAN, without any source ports:
DGS-3420-28SC:admin#config rspan vlan vlan_id 2 source
Command: config rspan vlan vlan_id 2 source
Success.
To configure RSPAN redirect for “VLAN 2” to ports 18 and 19:
DGS-3420-28SC:admin#config rspan vlan vlan_name vlan2 redirect add ports 18-19
Command: config rspan vlan vlan_name vlan2 redirect add ports 18-19
Success.
9-6 show rspan
Description
This command is used to display RSPAN configuration.
Format
show rspan {[vlan_name <vlan_name> | vlan_id <vlanid 1-4094>]}
To Next Page
Loading...
