D-Link xStack DGS-3420 Series - Config Dscp Trust

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
812
DGS-3420-28SC:admin#show dscp map 1:1 dscp_dscp
Command: show dscp map 1:1 dscp_dscp
DSCP to DSCP Mapping:
--------------------------------------------------------------
Port 1:1 | 0 1 2 3 4 5 6 7 8 9
-----------+--------------------------------------------------
0 | 0 1 2 3 4 5 6 7 8 9
1 | 10 11 12 13 14 15 16 17 18 19
2 | 20 21 22 23 24 25 26 27 28 29
3 | 30 31 32 33 34 35 36 37 38 39
4 | 40 41 42 43 44 45 46 47 48 49
5 | 50 51 52 53 54 55 56 57 58 59
6 | 60 61 62 63
--------------------------------------------------------------
DGS-3420-28SC:admin#
5-18 config dscp trust
Description
This command is used to configure the state of DSCP trust per port. When DSCP is not trusted,
802.1p is trusted.
Format
config dscp trust [<portlist> | all] state [enable | disable]
Parameters
<portlist> - Enter the list of port used for this configuration here.
all - Specify that the command apply to all ports on the Switch.
state - Enable or disable to trust DSCP. By default, DSCP trust is disabled.
enable - Specify that the DSCP trust state will be enabled.
disable - Specify that the DSCP trust state will be disabled.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
Enable DSCP trust on ports 1:1-1:8.