D-Link xStack DGS-3420 Series - Show Cfm Ports

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
199
Parameters
<portlist> - Specify the logical port list.
state - Specify the CFM function status.
enable - Specify to enable the CFM function.
disable - Specify to disable the CFM function.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To enable the CFM function on ports 2 to 5:
DGS-3420-28SC:admin#config cfm ports 2-5 state enable
Command: config cfm ports 2-5 state enable
Success.
DGS-3420-28SC:admin#
14-13 show cfm ports
Description
This command is used to display the CFM state of specified ports.
Format
show cfm ports <portlist>
Parameters
<portlist> - Specify the logical port list.
Restrictions
None.
Example
To display the CFM state for ports 3 to 6:
DGS-3420-28SC:admin#show cfm ports 3-6
Command: show cfm ports 3-6
Port State
----- -------
3 Enabled