D-Link xStack DGS-3420 Series - Config Authentication Ports

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
233
Parameters
case - (Optional) Specifies the case format used.
lowercase - Specifies using the lowercase format, the RADIUS authentication username will
be formatted as: aa-bb-cc-dd-ee-ff.
uppercase - Specifies using the uppercase format, the RADIUS authentication username will
be formatted as: AA-BB-CC-DD-EE-FF.
delimiter - (Optional) Specifies the delimiter format used.
hyphen - Specifies using the “-“ as delimiter, the format is: AA-BB-CC-DD-EE-FF
colon - Specifies using the “:“ as delimiter, the format is: AA:BB:CC:DD:EE:FF
dot - Specifies using the “.“ as delimiter, the format is: AA.BB.CC.DD.EE.FF
none - Specifies not using any delimiter, the format is: AABBCCDDEEFF
number - (Optional) Specifies the delimiter number used.
1 - Single delimiter, the format is: AABBCC.DDEEFF
2 - Double delimiter, the format is: AABB.CCDD.EEFF
5 - Multiple delimiter, the format is: AA.BB.CC.DD.EE.FF
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure the MAC address format to IETF style:
DGS-3420-28SC:admin#config authentication mac_format case uppercase delimiter
hyphen number 5
Command: config authentication mac_format case uppercase delimiter hyphen number 5
Success.
DGS-3420-28SC:admin#
18-5 config authentication ports
Description
This command is used to configure authorization mode and authentication method on ports.
Format
config authentication ports [<portlist> | all] {auth_mode [port_based | host_based {vlanid
<vid_list> state [enable | disable]}] | multi_authen_methods [none | any | dot1x_impb |
impb_jwac | impb_wac | mac_impb]}(1)
Parameters
<portlist> - Specify a port or range of ports to configure.
all - Specify to configure all ports.
auth_mode - (Optional) The authorization mode is port-based or host-based.