D-Link xStack DGS-3420 Series User Manual

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
680
Chapter 60 Modify Login Banner
and Prompt Commands
config greeting_message {default}
show greeting_message
config command_prompt [<string 16> | username | default]
60-1 config greeting_message
Description
This command is used to modify the login banner.
Format
config greeting_message {default}
Parameters
default – (Optional) Adding this parameter to the config greeting_message command will return the
greeting message (banner) to its original factory default entry.
Restrictions
• When users issue the “reset” command, the modified banner will remain in tact. Yet, issuing
the “reset system” will return the banner to its original default value.
• The maximum character capacity for the banner is 24 lines with 80 characters per line.
• In the following example, Ctrl+W will save the modified banner only to the DRAM. Users must
enter the “save” command to save this entry to the Flash memory.
• Only Administrator and Operator-level users can issue this command.
Example
To edit the banner:
DGS-3420-28SC:admin#config greeting_message
Command: config greeting_message
Greeting Messages Editor
===============================================================================
DGS-3420-28SC Gigabit Ethernet Switch

D-Link xStack DGS-3420 Series Specifications

General

Brand	D-Link
Model	xStack DGS-3420 Series
Category	Switch
Language	English