D-Link xStack DGS-3420 Series - Chapter 65 Packet Storm Commands

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
737
Chapter 65 Packet Storm
Commands
config traffic control [<portlist> | all] {broadcast [enable | disable] | multicast [enable | disable] |
unicast [enable | disable] | action [drop | shutdown] | [threshold <value 0-255000> |
{broadcast_threshold <value 0-255000> | multicast_threshold <value 0-255000> |
unicast_threshold <value 0-255000>}] | countdown [<min 0> | <min 3-30> | disable] | time_interval
<sec 5-600>}(1)
config traffic control auto_recover_time [<min 0> | <min 1-65535>]
config traffic control log state [enable | disable]
config traffic trap [none | storm_occurred | storm_cleared | both]
show traffic control {<portlist>}
65-1 config traffic control
Description
This command is used to configure broadcast/multicast/unicast storm control. The broadcast storm
control commands provide a hardware storm control mechanism only. These packet storm control
commands include hardware and software mechanisms to provide shutdown, recovery, and trap
notification functions.
Format
config traffic control [<portlist> | all] {broadcast [enable | disable] | multicast [enable | disable] |
unicast [enable | disable] | action [drop | shutdown] | [threshold <value 0-255000> |
{broadcast_threshold <value 0-255000> | multicast_threshold <value 0-255000> |
unicast_threshold <value 0-255000>}] | countdown [<min 0> | <min 3-30> | disable] |
time_interval <sec 5-600>}(1)
Parameters
<portlist> - Specify a range of ports to be configured.
all - Specify all ports are to be configured.
broadcast - Specify the broadcast storm status.
enable - Enable broadcast storm control.
disable - Disable broadcast storm control.
multicast - Specify the multicast storm status.
enable - Enable multicast storm control.
disable - Disable multicast storm control.
unicast - Specify the unknown unicast packet storm status.
enable - Enable unknown unicast packet storm control (only support drop action).
disable - Disable unknown unicast packet storm control.
action - Specify the action.
drop - This is implemented in hardware.
shutdown - This is implemented in software. If this is chosen, threshold, countdown, and