D-Link xStack DGS-3420 Series - Create Wac User

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
1053
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure a TCP port which the WAC switch listens to:
DGS-3420-28SC:admin# config wac switch_http_port 8888 http
Command: config wac switch_http_port 8888 http
Success.
DGS-3420-28SC:admin#
34-10 create wac user
Description
This command is used to create accounts for Web-based Access Control. This user account is
independent of the login user account. If VLAN is not specified, the user will not get a VLAN assigned
after the authentication.
Format
create wac user <username 15> {[vlan <vlan_name 32> | vlanid <vlanid 1-4094>]}
Parameters
<username 15> - Specify the user account for Web-based Access Control.
vlan - (Optional) Specify the authentication VLAN name.
<vlan_name 32> - Specify the authentication VLAN name. The VLAN name can be up to 32
characters long.
vlanid - (Optional) Specify the authentication VLAN ID number.
<vlanid 1-4094> - Specify the authentication VLAN ID number. The VLAN ID must be between 1
and 4094.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To create a WAC account:
DGS-3420-28SC:admin# create wac user abc vlanid 123
Command: create wac user abc vlanid 123
Enter a case-sensitive new password:**
Enter the new password again for confirmation:**
Success.