D-Link xStack DGS-3420 Series - Chapter 7 Routing Information Protocol (RIP) Command List; Enable Rip

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
828
Chapter 7 Routing Information
Protocol (RIP) Command
List
enable rip
config rip [ipif <ipif_name 12> | all] {authentication [enable <password 16> | disable] | tx_mode
[disable | v1_only | v1_compatible | v2_only] | rx_mode [v1_only | v2_only | v1_or_v2 | disable] |
state [enable | disable]}(1)
config rip timers {update <sec 5-65535> | timeout <sec 5-65535> | garbage_collection <sec 5-
65535>}(1)
disable rip
show rip {ipif <ipif_name 12>}
7-1 enable rip
Description
This command is used to enable RIP for the Switch. The default setting is disabled.
Format
enable rip
Parameters
None.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To enable RIP:
DGS-3420-28SC:admin# enable rip
Command: enable rip
Success.
DGS-3420-28SC:admin#