D-Link xStack DGS-3420 Series - Show Ipv6 Route

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
481
Format
delete ipv6route [[default | <ipv6networkaddr>] [<ipif_name 12> <ipv6addr> | <ipv6addr> |
ip_tunnel <tunnel_name 12>] | all]
Parameters
default - Specifies the default route.
<ipv6networkaddr> - Specifies the IPv6 network address.
<ipif_name 12> <ipv6addr> - Specifies the IP interface name.
<ipv6addr> - Specifies the next hop address for the IPv6 route
ip_tunnel - Specifies the IPv6 tunnel name used.
<tunnel_name 12> - Enter the IPv6 tunnel name used here. This name can be up to 12
characters long.
all - Specifies that all static created routes will be deleted.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To delete an IPv6 static route:
DGS-3420-28SC:admin#delete ipv6route default System FEC0::5
Command: delete ipv6route default System FEC0::5
Success.
DGS-3420-28SC:admin#
41-6 show ipv6route
Description
This command is used to display the Switch’s current IPv6 routing table.
Format
show ipv6route {[<ipv6networkaddr> | <ipv6addr>]} {[static | ripng | hardware]}
Parameters
<ipv6networkaddr> - Enter the IPv6 destination network address of the route.
<ipv6addr> - Enter the IPv6 address.
static - Display the static route entries.
ripng - Display the RIPng route entries.
hardware - Display the route entries which have been written into hardware table.