D-Link xStack DGS-3420 Series - Show Dscp Map

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
811
Example
To configure the mapping of the DSCP priority to priority 1:
DGS-3420-28SC:admin#config dscp map 1:1-1:8 dscp_priority 1 to 1
Command: config dscp map 1:1-1:8 dscp_priority 1 to 1
Success.
DGS-3420-28SC:admin#
To configure the global mapping of the DSCP priority to priority 1:
DGS-3420-28SC:admin#config dscp map dscp_priority 1 to 1
Command: config dscp map dscp_priority 1 to 1
Success.
DGS-3420-28SC:admin#
5-17 show dscp map
Description
This command is used to show DSCP trusted port list and mapped color, priority and DSCP.
Format
show dscp map {<portlist>} [dscp_priority | dscp_dscp] {dscp <dscp_list>}
Parameters
<portlist> - (Optional) A range of ports to show. If no parameter is specified, all ports’ dscp mapping
will be displayed.
dscp_priotity - Specify a list of DSCP value to be mapped to a specific priority.
dscp_dscp - Specify a list of DSCP value to be mapped to a specific DSCP.
dscp - (Optional) This specifies DSCP value that will be mapped.
<dscp_list> - Enter the DSCP list here.
Restrictions
None.
Example
In case of project support per port configure, show DSCP map configuration on port 1:1.