xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
271
Parameters
<value 1-12> - Enter the box ID used here. This value must be between 1 and 12.
all - Specifies that all the box IDs will be used.
sio1 - Specifies that the first stacking port will be used.
sio2 - Specifies that the second stacking port will be used.
Restrictions
Only Administrator-level users can issue this command.
Example
To show packet statistics information of the SIO port:
DGS-3420-28SC:admin#debug show packet ports box_id all sio1
Command: debug show packet ports box_id all sio1
Box ID 1 SIO 1:
Frame Size/Type Frame Counts Frames/sec
--------------- ---------------------- -----------
64 0 0
65-127 0 0
128-255 0 0
256-511 0 0
512-1023 0 0
1024-1518 0 0
1519-2047 0 0
2048-4095 0 0
4096-9216 0 0
Unicast RX 0 0
Multicast RX 0 0
Broadcast RX 0 0
CTRL+C ESC q Quit SPACE n Next Page p Previous Page r Refresh
19-36 debug vrrp
Description
This command is used to set VRRP debug flags.
Format
debug vrrp [vr_state_change | packet [all | {receiving | sending}] | mac_addr_update |
interface_change | timers] state [enable | disable]
To Next Page
Loading...
