D-Link xStack DGS-3420 Series - Clear Counters

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
714
Parameters
unit - Specifies which unit on the stacking system. If it is not specified, it refers to the master unit.
<unit_id> - Enter the unit ID used here.
Restrictions
None.
Example
To display Flash utilization:
DGS-3420-28SC:admin# show utilization flash
Command: show utilization flash
FLASH Memory Utilization :
Total FLASH : 30608 KB
Used FLASH : 4786 KB
Utilization : 15%
CTRL+C ESC q Quit SPACE n Next Page p Previous Page r Refresh
63-6 clear counters
Description
This command is used to clear the switch’s statistics counters.
Format
clear counters {ports <portlist>}
Parameters
ports - Specify a range of ports to be configured. The beginning and end of the port list range are
separated by a dash.
<portlist> - Specify a range of ports to be configured.
Note: If no parameter is specified, the system will count all of the ports.
Restrictions
Only Administrator and Operator-level users can issue this command.