D-Link xStack DGS-3420 Series - Chapter 56 Mirror Commands

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
636
Chapter 56 Mirror Commands
create mirror group_id <value 1-4>
config mirror port <port> {[add | delete] source ports <portlist> [rx | tx | both]}
config mirror group_id <value 1-4> {target_port <port> | [add | delete] source ports <portlist> [rx | tx |
both] | state [enable | disable]}(1)
delete mirror group_id <value 1-4>
enable mirror
disable mirror
show mirror {group_id <value 1-4>}
56-1 create mirror group_id
Description
This command used to create a mirror group. If the mirror group has existed, do nothing and return
success.
Format
create mirror group_id <value 1-4>
Parameters
<value 1-4> - Enter the mirror group ID used here. This value must be between 1 and 4.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
Create mirror group 3:
DGS-3420-28SC:admin# create mirror group_id 3
Command: create mirror group_id 3
Success.
DGS-3420-28SC:admin#