D-Link xStack DGS-3420 Series - Show Ports

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
956
DGS-3420-28SC:admin#
23-2 show ports
Description
This command is used to display the current configurations of a range of ports.
Format
show ports {<portlist>} {[description | err_disabled | auto_negotiation | details | media_type]}
Parameters
<portlist> - (Optional) Specify a range of ports to be displayed.
description - (Optional) Specify to display the port description.
err_disabled - (Optional) Specify to display disabled information.
auto_negotiation - (Optional) Specifies to display detailed auto-negotiation information.
details - (Optional) Specify to indicate if port detail information will be included in the display.
media_type - (Optional) Specify to display the current port media type and STP information. For FE
ports, the media type should be 100BASE-TX. For GE ports (the combo port), if the current active
port is the fiber port, the media type is 1000BASE-FX or 100BASE-FX; if the current active port is
the copper port, the media type is 1000BASE-T and SFP information is displayed when SFP is
existent.
Note: If no parameter is specified, all ports will be displayed.
Restrictions
None.
Example
To display the configuration of ports 1 to 4:
DGS-3420-28SC:admin#show ports 1:1-1:4
Command: show ports 1:1-1:4
Port State/ Settings Connection Address
MDIX Speed/Duplex/FlowCtrl Speed/Duplex/FlowCtrl Learning
------- -------- --------------------- ---------------------- ---------
1:1 Enabled Auto/Disabled Link Down Enabled
Auto
1:2 Enabled Auto/Disabled Link Down Enabled
Auto
1:3 Enabled Auto/Disabled Link Down Enabled
Auto