xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
583
51-6 config lldp notification_interval
Description
This command is used to configure LLDP timer values. This will globally change the interval between
successive LLDP change notifications generated by the switch.
Format
config lldp notification_interval <sec 5-3600>
Parameters
<sec 5-3600> - Specify the notification interval range is from 5 to 3600 seconds. The default setting
is 5 seconds.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To change the notification interval to 10 seconds:
DGS-3420-28SC:admin#config lldp notification_interval 10
Command: config lldp notification_interval 10
Success.
51-7 config lldp ports
Description
Use this command to configure LLDP options by port. Enable or disable each port for sending change
notification to configured SNMP trap receiver(s) if an LLDP data change is detected in an
advertisement received on the port from an LLDP neighbor. The definition of change includes new
available information, information timeout, information update. And the changed type includes any
data update /insert/remove.
The admin status options enable to control which ports participate in LLDP traffic and whether the
participating ports allow LLDP traffic in only one direction or in both directions.
The config management address command specifies whether system’s IP address needs to be
advertised from the specified port. For layer 3 devices, each managed address can be individually
To Next Page
Loading...
Need help?
General