xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
272
Parameters
vr_state_change - Specify the VRRP virtual router state change debug flag.
packet - Specify to set the VRRP packet flags.
all - Sets VRRP all packet debug flags.
receiving - Set the VRRP packet receiving flag.
sending - Set the VRRP packet sending flag.
mac_addr_update - Specify the VRRP MAC address update debug flag.
interface_change - Specify the VRRP interface state change debug flag.
timers - Specify the state of the VRRP timers debug flag.
state - Specify the state of the configured VRRP debug flag.
enable - Specify that the configured VRRP debug flag will be enabled.
disable - Specify that the configured VRRP debug flag will be disabled.
Restrictions
Only Administrator level can issue this command.
Example
To enable the VRRP virtual router state change debug flag:
DGS-3420-28SC:admin#debug vrrp vr_state_change state enable
Command: debug vrrp vr_state_change state enable
Success.
To enable all VRRP packet debug flags:
DGS-3420-28SC:admin#debug vrrp packet all state enable
Command: debug vrrp packet all state enable
Success.
To enable the VRRP virtual MAC address update debug flag:
DGS-3420-28SC:admin#debug vrrp mac_addr_update state enable
Command: debug vrrp mac_addr_update state enable
Success.
To enable the VRRP interface state change debug flag:
To Next Page
Loading...
