D-Link xStack DGS-3420 Series User Manual

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
1050
command to set the RADIUS protocol, users must make sure the RADIUS server added by the config
radius command supports the protocol.
Format
config wac method [local | radius]
Parameters
local - Specify the authentication will be done via the local database.
radius - Specify the authentication will be done via the RADIUS server.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure the WAC authentication method:
DGS-3420-28SC:admin#config wac method radius
Command: config wac method radius
Success.
DGS-3420-28SC:admin#
34-6 config wac default_redirpath
Description
This command is used to configure the WAC default redirect path. If default redirect path is configured,
the user will be redirected to the default redirect path after successful authentication. When the string
is cleared, the client will not be redirected to another URL after successful authentication.
Format
config wac default_redirpath <string 128>
Parameters
<string 128> - Specify the URL that the client will be redirected to after successful authentication. By
default, the redirected path is cleared.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.

D-Link xStack DGS-3420 Series Specifications

General

Brand	D-Link
Model	xStack DGS-3420 Series
Category	Switch
Language	English