D-Link xStack DGS-3420 Series - Page 103

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
98
4-49 show tacacs source_ipif
Description
This command is used to display the specified source interface for all outgoing TACACS packets.
Format
show tacacs source_ipif
Parameters
None.
Restrictions
Only Administrator level can issue this command.
Example
To display the specified source interface for all outgoing TACACS packets.
DGS-3420-28SC:admin#show tacacs source_ipif
Command: show tacacs source_ipif
IP Interface : if_v200
IPv4 Address : None
DGS-3420-28SC:admin#
4-50 config accounting
Description
This command is used to configure a user-defined or default method list of accounting methods.
Format
config accounting [default | method_list_name <string 15>] method {tacacs+ | radius |
server_group <string 15> | none}
Parameters
default - Specifies the default method list of accounting methods.
method_list_name - Specifies the user-defined method list of accounting methods.
<string 15> - Enter the user-defined method list name here. This name can be up to 15
characters long.
method - Specifies the accounting method used.
tacacs+ - Specifies to use the built-in server group 'tacacs+'.