D-Link xStack DGS-3420 Series - Page 102

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
97
Example
To configure the XTACACS server host:
DGS-3420-28SC:admin#config xtacacs server_host 10.1.1.224 retransmit 5
Command: config xtacacs server_host 10.1.1.224 retransmit 5
Key is meaningless for TACACS and XTACACS.
Success.
DGS-3420-28SC:admin#
4-48 config tacacs source_ipif
Description
This command is used to specify the source interface for all outgoing TACACS packets.
Format
config tacacs source_ipif [<ipif_name 12> {<ipaddr>} | none]
Parameters
<ipif_name 12> - Enter the interface name as source interface for all outgoing TACACS packets.
<ipaddr> - (Optional) Enter the IP address as source IPv4 address for all outgoing TACACS
packets.
none - Specifies to revert to the default route table for all outgoing TACACS packet.
Restrictions
Only Administrator level can issue this command.
Example
To specify a source interface for all outgoing TACACS packets:
DGS-3420-28SC:admin#config tacacs source_ipif if_v200
Command: config tacacs source_ipif if_v200
Success.
DGS-3420-28SC:admin#