D-Link xStack DGS-3420 Series - Page 155

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
150
<value 1-64> - Enter the port group ID here. This value must be between 1 and 64.
name - Specifies the port group name.
<name 16> - Enter the port group name here. This name can be up to 16 characters long.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To create a port group:
DGS-3420-28SC:admin# create port_group id 2 name group2
Command: create port_group id 2 name group2
Success.
DGS-3420-28SC:admin#
6-9 config port_group
Description
This command is used to add or delete a port list to a port group.
Format
config port_group [id <value 1-64> | name <name 16>] [add | delete] [<portlist> | all]
Parameters
id - Specifies the port group ID.
<value 1-64> - Enter the port group ID used here. This value must be between 1 and 64.
name - Specifies the port group name.
<name 16> - Enter the port group name here. This name can be up to 16 characters long.
add - Add a port list to this port group.
delete - Delete a port list from this port group.
<portlist> - Enter a list of ports used for the configuration here.
all - Specifies that all the ports will be used for this configuration.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
Add port list “1-3” to the port group which ID is “2”: