D-Link xStack DGS-3420 Series - Page 289

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
284
<ipaddr> - Specify the DHCP/BOOTP server IP address.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To add an IP destination address to the switch’s DHCP relay table:
DGS-3420-28SC:admin#config dhcp_relay add ipif System 10.43.21.12
Command: config dhcp_relay add ipif System 10.43.21.12
Success.
DGS-3420-28SC:admin#
21-3 config dhcp_relay delete ipif
Description
This command is used to delete an IP destination address from the switch’s DHCP relay table.
Format
config dhcp_relay delete ipif <ipif_name 12> <ipaddr>
Parameters
<ipif_name 12> - Specify the name of the IP interface which contains the IP address below.
<ipaddr> - Specify the DHCP/BOOTP server IP address.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To delete an IP destination address from the switch’s DHCP relay table:
DGS-3420-28SC:admin#config dhcp_relay delete ipif System 10.43.21.12
Command: config dhcp_relay delete ipif System 10.43.21.12
Success.
DGS-3420-28SC:admin#