xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
25
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To save the current configuration to the bootup configuration file:
Command: save
Saving all configurations to NV-RAM.......... Done.
To save the current configuration to destination file, named 1:
DGS-3420-28SC:admin#save config 1
Command: save config 1
Saving all configurations to NV-RAM.......... Done.
To save a log to NV-RAM:
DGS-3420-28SC:admin#save log
Command: save log
Saving all system logs to NV-RAM............. Done.
To save all the configurations and logs to NV-RAM:
DGS-3420-28SC:admin#save all
Command: save all
Saving configuration and logs to NV-RAM...... Done.
2-21 reboot
Description
This command is used to restart the switch.
To Next Page
Loading...
Need help?
General