D-Link xStack DGS-3420 Series - Page 439

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
434
characters.
interval - The periodically send gratuitous ARP interval time, in seconds.
<value 0-65535> - Specify the value between 0 and 65535. 0 (zero) means not to send gratuitous
ARP request packets periodically. By default, the interval is 0 (zero).
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure the gratuitous ARP interval to 5 for the IPIF System:
DGS-3420-28SC:admin#config gratuitous_arp send periodically ipif System interval 5
Command: config gratuitous_arp send periodically ipif System interval 5
Success.
DGS-3420-28SC:admin#
37-7 show gratuitous_arp
Description
This command is used to display gratuitous ARP configuration.
Format
show gratuitous_arp {ipif <ipif_name 12>}
Parameters
ipif - (Optional) The interface name of the L3 interface.
<ipif_name 12> - Specify the interface name. The maximum length is 12 characters.
Restrictions
None.
Example
To display the gratuitous ARP log and trap state:
DGS-3420-28SC:admin#show gratuitous_arp
Command: show gratuitous_arp
Send on IPIF Status Up : Disabled
Send on Duplicate IP Detected : Disabled
Gratuitous ARP Learning : Disabled