D-Link xStack DGS-3420 Series - Page 449

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
444
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure the IGMP snooping querier:
DGS-3420-28SC:admin#config igmp_snooping querier vlan_name default
query_interval 125 state enable
Command: config igmp_snooping querier vlan_name default query_interval 125
state enable
Success.
DGS-3420-28SC:admin#
39-3 config router_ports
Description
This command is used to designate a range of ports as being connected to multicast-enabled routers.
This will ensure that all packets with such a router as its destination will reach the multicast-enabled
router, regardless of protocol.
Format
config router_ports [<vlan_name 32> | vlanid <vlanid_list>] [add | delete] <portlist>
Parameters
<vlan_name 32> - Specify the name of the VLAN on which the router port resides.
vlanid - Specify the VLAN ID list.
<vlanid_list> - Specify the VLAN ID list.
add - Specify to add the router ports.
delete - Specify to delete the router ports.
<portlist> - Specify a range of ports to be configured.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To set up static router ports:
DGS-3420-28SC:admin#config router_ports default add 1-10
Command: config router_ports default add 1-10
Success.