xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
41
be any value from 1 to 65535.
<sec 1-65535> - The transmit period value must be between 1 an 65535 seconds.
supp_timeout - (Optional) The initialization value of the aWhile timer when timing out the supplicant.
Its default value is 30 s and can be any value from 1 to 65535.
<sec 1-65535> - The timeout value must be between 1 an 65535 seconds.
server_timeout - (Optional) The initialization value of the aWhile timer when timing out the
authentication server. Its default value is 30 and can be any value from 1 to 65535.
<sec 1-65535> - The server timeout value must be between 1 an 65535 seconds.
max_req - (Optional) The maximum number of times that the authenitcation PAE state machine will
retransmit an EAP Request packet to the supplicant. Its default value is 2 and can be any number
from 1 to 10.
<value 1-10> - The maximum require number must be between 1 and 10.
reauth_period - (Optional) It's a non-zero number of seconds, which is used to be the re-
authentication timer. The default value is 3600.
<sec 1-65535> - The reauthentication period value must be between 1 an 65535 seconds.
max_users - (Optional) Set the maximum number of users between 1 and 448.
<value 1-448> - The maximum users value must be between 1 and 448.
no_limit - Set an unlimited number of users.
enable_reauth - (Optional) Enable or disable the re-authentication mechanism for a specific port.
enable - Enable the re-authentication mechanism for a specific port.
disable - Disable the re-authentication mechanism for a specific port.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure the parameters that control the operation of the authenticator associated with a port:
DGS-3420-28SC:admin# config 802.1x auth_parameter ports 1-20 direction both
Command: config 802.1x auth_parameter ports 1-20 direction both
Success.
3-12 config 802.1x authorization attributes radius
Description
This command is used to enable or disable the acceptation of an authorized configuration. (To
configure that attributes, regarding VLAN, 802.1p, ACL and Ingress/Egress Bandwidth, please refer to
the Appendix section at the end of this document.)
Format
config 802.1x authorization attributes radius [enable | disable]
To Next Page
Loading...
