D-Link xStack DGS-3420 Series User Manual

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
483
DGS-3420-28SC:admin#create ipv6route redistribute dst ripng src local
Command: create ipv6route redistribute dst ripng src local
Success.
DGS-3420-28SC:admin#
41-8 config ipv6route redistribute dst ripng src
Description
This command is used to configure the metric to be associated with the redistributed routes imported
from a specified protocol to RIPng protocol.
Format
config ipv6route redistribute dst ripng src [local | static] {metric <value 0-16>}
Parameters
local - Redistribute local routes into RIPng.
static - Redistribute static routes into RIPng.
metric - (Optional) Specifies the RIPng route metric for the redistributed routes. When the metric
value is 0, the metric in the original route will become the metric of the redistributed RIPng
route transparently. If the metric of the original route is equal or greater than 16, the route will
be not redistributed.
<value 0-16> - Enter the value between 0 and 16.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure the RIPng route redistribution:
DGS-3420-28SC:admin#config ipv6route redistribute dst ripng src local metric 6
Command: config ipv6route redistribute dst ripng src local metric 6
Success.
DGS-3420-28SC:admin#
41-9 delete ipv6route redistribute dst ripng src
Description
This command is used to remove RIPng route redistribution to stop importing routes from other routing
domain into RIPng domain.

D-Link xStack DGS-3420 Series Specifications

General

Brand	D-Link
Model	xStack DGS-3420 Series
Category	Switch
Language	English