D-Link xStack DGS-3420 Series - Page 502

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
497
Parameters
<ipif_name 12> - Specify the IPv6 interface name.
all - Specify all the IPv6 interface names.
ipv6address - Specify the IPv6 address of the neighbor.
<ipv6addr> - Specify the IPv6 address
static - Specify to display the IPv6 static neighbor cache entries.
dynamic - Specify to display the IPv6 dynamic entries.
all - Specify to display all IPv6 addresses, static and dynamic.
hardware - (Optional) Specify to display all the neighbor cache entries which were written into the
hardware table.
Restrictions
None.
Example
To display all neighbor cache entries for the IP interface “System”:
DGS-3420-28SC:admin#show ipv6 neighbor_cache ipif System all
Command: show ipv6 neighbor_cache ipif System all
FE80::215:72FF:FE36:104 State: Reachable
MAC Address : 00-15-72-36-01-04 Port : 1:21
Interface : System VID : 1
Total Entries: 1
DGS-3420-28SC:admin#
43-4 config ipv6 nd ns ipif
Description
This command is used to configure the NS retransmit time of a specified interface.
Format
config ipv6 nd ns ipif <ipif_name 12> retrans_time <millisecond 0-4294967295>
Parameters
<ipif_name 12> - Specify the name of the interface. The maximum length is 12 characters.
retrans_time - Specify the neighbor solicitation’s retransmit timer in milliseconds. It has the same
value as ra retrans_time in the config ipv6 nd ra command. If one is configured, the other will
change too.
<millisecond 0-4294967295> - Specify the neighbor solicitation’s retransmit timer in milliseconds.
It has the same value as ra retrans_time in the config ipv6 nd ra command. If one is
configured, the other will change too. Specify a time between 0 and 4294967295 milliseconds.