D-Link xStack DGS-3420 Series - Page 504

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
499
other_config_flag - Specify to enable or disable the function.
enable - When set to enable, it indicates that hosts receiving this RA must use a stateful address
configuration protocol to obtain on-address configuration information.
disable - Set to disable to stop hosts receiving this RA from using a stateful address configuration
protocol to obtain on-address configuration information.
min_rtr_adv_interval - Specify the minimum time allowed between sending unsolicited multicast
Router Advertisements from the interface, in seconds. It must be no less than 3 seconds and no
greater than .75 * MaxRtrAdvInterval. The default is 0.33 * MaxRtrAdvInterval.
<sec 3-1350> - Specify the time between 3 and 1350 seconds.
max_rtr_adv_interval - Specify the maximum time allowed between sending unsolicited multicast
Router Advertisements from the interface, in seconds. It must be no less than 4 seconds and no
greater than 1800 seconds. The default is 600 seconds.
<sec 4-1800> - Specify the time between 4 and 1800 seconds.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure the RA state as enabled and the life_time of the “tiberius” interface to be 1000 seconds:
DGS-3420-28SC:admin#config ipv6 nd ra ipif tiberius state enable life_time 1000
Command: config ipv6 nd ra ipif tiberius state enable life_time 1000
Success.
DGS-3420-28SC:admin#
43-6 config ipv6 nd ra prefix_option ipif
Description
This command is used to configure the prefix option for the router advertisement function.
Format
config ipv6 nd ra prefix_option ipif <ipif_name 12> <ipv6networkaddr> {preferred_life_time
<sec 0-4294967295> | valid_life_time <sec 0-4294967295> | on_link_flag [enable | disable] |
autonomous_flag [enable | disable]}(1)
Parameters
<ipif_name 12> - Specify the name of the interface. The maximum length is 12 characters.
<ipv6networkaddr> - Specify the IPv6 network address.
preferred_life_time - Specify the number in seconds that an address, based on the specified prefix
using the stateless address configuration, remains in preferred state.
<sec 0-4294967295> - Specify the time between 0 and 4294967295 seconds. For an infinite valid
lifetime the value can be set to 4294967295.
valid_life_time - Specify the number of seconds that an address, based on the specified prefix,
using the stateless address configuration, remains valid.