D-Link xStack DGS-3420 Series - Page 518

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
513
44-11 enable address_binding trap_log
Description
This command is used to send trap and log messages when an address binding module detects illegal
IP and MAC addresses.
Format
enable address_binding trap_log
Parameters
None.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To enable the address binding trap and log:
DGS-3420-28SC:admin#enable address_binding trap_log
Command: enable address_binding trap_log
Success.
DGS-3420-28SC:admin#
44-12 disable address_binding trap_log
Description
This command is used to disable address binding trap logs.
Format
disable address_binding trap_log
Parameters
None.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.