xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
538
45-13 config jwac redirect
Description
This command is used to configure redirect destination and delay time before an unauthenticated host
is redirected to the quarantine server or the JWAC login web page. The unit of delay time is seconds.
0 means no delaying the redirect.
Format
config jwac redirect {destination [quarantine_server | jwac_login_page] | delay_time <sec 0-
10>}(1)
Parameters
destination - Specify the destination which the unauthenticated host will be redirected to.
quarantine_server - Specify the unauthenticated host will be redirected to the quarantine_server.
jwac_login_page - Specify the unauthenticated host will be redirected to the jwac_login_page.
delay_time - Specify the time interval after which the unauthenticated host will be redirected.
<sec 0-10> - Specify the time interval after which the unauthenticated host will be redirected. The
delay time must be between 0 and 10 seconds.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure JWAC redirect destination to JWAC login web page and a delay time of 5 seconds:
DGS-3420-28SC:admin#config jwac redirect destination jwac_login_page delay_time 5
Command: config jwac redirect destination jwac_login_page delay_time 5
Success.
45-14 config jwac virtual_ip
Description
This command is used to configure JWAC virtual IP addresses used to accept authentication requests
from an unauthenticated host. The virtual IP of JWAC is used to accept authentication request from
unauthenticated host. Only requests sent to this IP will get correct responses. This IP does not
respond to ARP requests or ICMP packets.
Format
config jwac virtual_ip <ipaddr> {url [<string 128> | clear]}
To Next Page
Loading...
Need help?
General