D-Link xStack DGS-3420 Series - Page 548

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
543
Format
create jwac user <username 15> {vlan <vlanid 1-4094>}
Parameters
<username 15> - Specify the user name to be created.
vlan - (Optional) Specify the target VLAN ID for the authenticated host which uses this user account
to pass authentication.
<vlanid 1-4094> - Specify the target VLAN ID for the authenticated host which uses this user
account to pass authentication. The VLAN ID value must be between 1 and 4094.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To create a JWAC user in the local DB:
DGS-3420-28SC:admin# create jwac user 112233
Command: create jwac user 112233
Enter a case-sensitive new password:***
Enter the new password again for confirmation:***
Success.
DGS-3420-28SC:admin#
45-20 config jwac user
Description
This command configures a JWAC user.
Format
config jwac user <username 15> {vlan <vlanid 1-4094>}
Parameters
<username 15> - Specify the user name to be configured.
vlan - (Optional) Specify the target VLAN ID for the authenticated host which uses this user account
to pass authentication.
<vlanid 1-4094> - Specify the target VLAN ID for the authenticated host which uses this user
account to pass authentication. The VLAN ID value must be between 1 and 4094.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.