D-Link xStack DGS-3420 Series - Page 579

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
574
50-2 delete link_aggregation group_id
Description
This command is used to delete a previously configured link aggregation group.
Format
delete link_aggregation group_id <value 1-32>
Parameters
<value 1-32> - Specify the group ID. The group number identifies each of the groups. The switch
allows up to 32 link aggregation groups to be configured.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To delete a link aggregation group:
DGS-3420-28SC:admin#delete link_aggregation group_id 3
Command: delete link_aggregation group_id 3
Success.
DGS-3420-28SC:admin#
50-3 config link_aggregation group_id
Description
This command allows you to configure a link aggregation group that was created with the create
link_aggregation command above.
Format
config link_aggregation group_id <value 1-32> {master_port <port> | ports <portlist> | state
[enable | disable] | trap [enable | disable]} (1)
Parameters
<value 1-32> - Specify the group ID. The group number identifies each of the groups. The switch
allows up to 32 link aggregation groups to be configured.
master_port - Specify which port (by port number) of the link aggregation group will be the master
port. All of the ports in a link aggregation group will share the port configuration with the master
port.