D-Link xStack DGS-3420 Series - Page 630

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
625
guest_vlanid - Specify the VLAN ID of the guest VLAN.
<vlanid 1-4094> - Specify the VLAN ID of the guest VLAN. The guest VLAN ID must be between
1 and 4094.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To delete a MAC-based access control guest VLAN:
DGS-3420-28SC:admin#delete mac_based_access_control guest_vlan default
Command: delete mac_based_access_control guest_vlan default
Success.
DGS-3420-28SC:admin#
55-9 clear mac_based_access_control auth_state
Description
This command is used to clear the authentication state of a user (or port). The port (or the user) will
return to un-authenticated state. All the timers associated with the port (or the user) will be reset.
Format
clear mac_based_access_control auth_state [ports [all | <portlist>] | mac_addr <macaddr>]
Parameters
ports - Specify the port range to clear the authentication state.
all - Specify all ports.
<portlist> - Specify a range of ports.
mac_addr - Specify to clear a specified host authentication state.
<macaddr> - Enter the MAC address here.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To clear the authentication state of all ports:
DGS-3420-28SC:admin#clear mac_based_access_control auth_state ports all
Command: clear mac_based_access_control auth_state ports all