D-Link xStack DGS-3420 Series - Page 706

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
701
Example
To enable SNMP linkchange trap support:
DGS-3420-28SC:admin#enable snmp linkchange_traps
Command: enable snmp linkchange_traps
Success.
DGS-3420-28SC:admin#
62-16 disable snmp linkchange_traps
Description
This command is used to disable SNMP linkchange trap support.
Format
disable snmp linkchange_traps
Parameters
None.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To disable SNMP linkchange trap support:
DGS-3420-28SC:admin#disable snmp linkchange_traps
Command: disable snmp linkchange_traps
Success.
DGS-3420-28SC:admin#
62-17 config snmp linkchange_traps ports
Description
This command is used to configure the sending of linkchange traps and per port control for sending of
change traps.