D-Link xStack DGS-3420 Series User Manual

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
705
Success.
DGS-3420-28SC:admin#
62-21 config trap source_ipif
Description
This command is used to force change the ipif information in trap messages. By default, trap
messages will carry the information of the ipif they belong to.
Format
config trap source_ipif [<ipif_name 12> {<ipaddr> | <ipv6addr>} | none]
Parameters
<ipif_name 12> - Specify the IP interface name. If only this parameter is specified, the IPv4 address
and the smallest IPv6 address of ipif_name will be used as source IP addresses.
<ipaddr> - (Optional) Specify the IPv4 address.
<ipv6addr> - (Optional) Specify the IPv6 address.
none - Specify to clear the configured source IP interface.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To configure the trap source IP interface:
DGS-3420-28SC:admin#config trap source_ipif inter4
Command: config trap source_ipif inter4
Success.
DGS-3420-28SC:admin#
To clear the configured trap source IP interface:
DGS-3420-28SC:admin#config trap source_ipif none
Command: config trap source_ipif none
Success.
DGS-3420-28SC:admin#

D-Link xStack DGS-3420 Series Specifications

General

Brand	D-Link
Model	xStack DGS-3420 Series
Category	Switch
Language	English