xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
740
Format
config traffic control log state [enable | disable]
Parameters
state - Specifies the traffic control log state.
enable - Specifies that traffic control state will be logged when a storm occurs.
disable - Specifies that the traffic control state will be disabled.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure the traffic log state on the Switch:
DGS-3420-28SC:admin# config traffic control log state enable
Command: config traffic control log state enable
Success.
65-4 config traffic trap
Description
This command is used to configure whether storm control notification will be generated or not while
traffic storm events are detected by a SW traffic storm control mechanism.
Note: A traffic control trap is active only when the control action is configured as shutdown. If
the control action is drop there will no traps issue while storm event is detected.
Format
config traffic trap [none | storm_occurred | storm_cleared | both]
Parameters
none - No notification will be generated when storm event is detected or cleared.
storm_occurred - A notification will be generated when a storm event is detected.
storm_cleared - A notification will be generated when a storm event is cleared.
both - A notification will be generated both when a storm event is detected and cleared.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
To Next Page
Loading...
Need help?
General