D-Link xStack DGS-3420 Series - Page 762

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
757
68-8 config port_security log state
Description
This command is used to enable or disable the port security log. When the port security log is enabled
and there is a new MAC that violates the pre-defined port security configuration, the MAC, port and
other relevant information will be logged, otherwise, no log will be generated.
Format
config port_security log state [enable | disable]
Parameters
enable - Specifies to enable the port security log.
disable - Specifies to disable the port security log.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To enable the port security log:
DGS-3420-28SC:admin# config port_security log state enable
Command: config port_security log state enable
Success.
DGS-3420-28SC:admin#
68-9 config port_security trap state
Description
This command is used to enable or disable the sending of port security traps. When the port security
trap is enabled and there is a new MAC that violates the pre-defined port security configuration, a trap
will be sent out with the information about the MAC address and port. If the port security trap is
disabled, no trap will be sent out for a MAC address violation.
Format
config port_security trap state [enable | disable]
Parameters
enable - Specifies to enable the port security trap.
disable - Specifies to disable the port security trap.