xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
767
70-4 config power_saving port
Description
This command is used to add or delete the power saving schedule on the port. When any schedule is
up, the specific port will be shut down (disabled).
Note: The port’s admin state has high priority. If the port’s admin state is disabled, the
specific port will always be shut down (disabled). Currently only three time ranges are
Format
config power_saving port [<portlist> | all] [[add | delete] time_range <range_name 32> |
clear_time_range]
Parameters
<portlist> - Specify a range of ports.
add - Specify to add a time range.
delete - Specify to delete a time range.
time_range - Specify the name of the time range.
<range_name32> - Enter a name for maximum 32 characters.
clear_time_range - Specify to clear all the time range of port.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To add a time range named “range_1” on port 1:
DGS-3420-28SC:admin#config power_saving port 1:1 add time_range range_1
Command: config power_saving port 1:1 add time_range range_1
Success.
To delete a time range named “range_2” on port 1:
DGS-3420-28SC:admin#config power_saving port 1:1 delete time_range range_2
Command: config power_saving port 1:1 delete time_range range_2
Success.
To Next Page
Loading...
Need help?
General