xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
787
Format
show ptp boundary {ports [<portlist> | all]}
Parameters
ports – (Optional) Specifies the list of port used for this display.
<portlist> - Enter the list of port used for this display here.
all - Specifies that all the ports will be used for this display.
Restrictions
None.
Example
To show the configured attributes of the boundary clock:
DGS-3420-28SC:admin# show ptp boundary
Command: show ptp boundary
PTP Priority1 Setting : 128
PTP Priority2 Setting : 127
To show the configured attributes of special ports 1:1-1:4 of the boundary clock:
DGS-3420-28SC:admin# show ptp boundary ports 1:1-1:4
Command: show ptp boundary ports 1:1-1:4
The attribute configurations of the ports of boundary:
DM : Delay Mechanism
AI : Announce Interval
CART : The Coefficient of Announce Receipt Timeout
SI : Synchronization Interval
EDRI : The Exponent of Delay_Request Interval
PDRI : Pdelay_Request Interval
Port DM AI CART SI EDRI PDRI State
1:1 P2P 2 3 1 1 8 Enabled
1:2 E2E 1 2 0.5 0 16 Enabled
1:3 P2P 2 5 1 2 8 Enabled
1:4 P2P 2 6 1 4 4 Enabled
To Next Page
Loading...
