D-Link xStack DGS-3420 Series User Manual

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
797
<value 8-10240000> - Specify an integer value from 8 to 10240000 to set a maximum limit in
Kbits/sec. The specified bandwidth limit may be equaled but not exceeded. This exact logical
limit or token value is hardware determined.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure port bandwidth:
DGS-3420-28SC:admin#config bandwidth_control 1-10 tx_rate 1024
Command: config bandwidth_control 1-10 tx_rate 1024
Success.
DGS-3420-28SC:admin#
5-2 show bandwidth_control
Description
This command is used to display the port bandwidth configurations. The bandwidth can also be
assigned by the RADIUS server through the authentication process. If the RADIUS server has
assigned the bandwidth, then the RADIUS-assigned bandwidth will be the effective bandwidth.
Format
show bandwidth_control {<portlist>}
Parameters
<portlist> - (Optional) Specify a range of ports to be displayed.
Note: If no parameter is specified, the system will display all port bandwidth configurations.
Restrictions
None.
Example
To display the port bandwidth control table for ports 1 to 2:

D-Link xStack DGS-3420 Series Specifications

General

Brand	D-Link
Model	xStack DGS-3420 Series
Category	Switch
Language	English