D-Link xStack DGS-3420 Series - Page 850

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
845
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure the safeguard engine:
DGS-3420-28SC:admin#config safeguard_engine state enable utilization rising 50
falling 30 trap_log enable
Command: config safeguard_engine state enable utilization rising 50 falling 30
trap_log enable
Success.
DGS-3420-28SC:admin#
10-2 show safeguard_engine
Description
This command is used to display safeguard engine information.
Format
show safeguard_engine
Parameters
None.
Restrictions
None.
Example
To display safeguard engine information:
DGS-3420-28SC:admin#show safeguard_engine
Command: show safeguard_engine
Safeguard Engine State : Disabled
Safeguard Engine Current Status : Normal Mode
===================================================
CPU Utilization Information:
Rising Threshold : 30%
Falling Threshold : 20%
Trap/Log State : Disabled