D-Link xStack DGS-3420 Series User Manual

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
852
Parameters
None.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To display the sFlow information:
DGS-3420-28SC:admin#show sflow
Command: show sflow
sFlow Version : V5
sFlow Address : 10.90.90.90
sFlow AddressV6: FE80::201:2FF:FE03:400
sFlow State : Enabled
DGS-3420-28SC:admin#
12-4 create sflow flow_sampler ports
Description
This command is used to create the sFlow flow sampler.
Format
create sflow flow_sampler ports [<portlist> | all] analyzer_server_id <value 1-4> {rate <value 0-
65535> | tx_rate <value 0-65535> | maxheadersize <value 18-256>}
Parameters
<portlist> - Specify the list of ports to be configured.
all - Specify to configure all ports.
analyzer_server_id - Specify the ID of an analyzer server where the packet will be forwarded.
<value 1-4> - Specify the ID of an analyzer server where the packet will be forwarded.
rate - (Optional) Specify the sampling rate for packet sampling.
<value 0-65535> - Specify the sampling rate for packet sampling. The configured rate value
multiplied by 256 is the actual rate. For example, if the rate is 20, the actual rate 5120. One
packet will be sampled from every 5120 packets. If set to 0, the sampler is disabled. If the
rate is not specified, its default value is 0.
tx_rate – Specifies the transmit rate.
<value 0-65535> - Enter the transmit rate used here. This value must be between 0 and
65535.
maxheadersize - (Optional) Specify the maximum number of leading bytes in the packet which
has been sampled that will be encapsulated and forwarded to the server.
<value 18-256> - Specify the maximum number of leading bytes in the packet which has been

D-Link xStack DGS-3420 Series Specifications

General

Brand	D-Link
Model	xStack DGS-3420 Series
Category	Switch
Language	English