D-Link xStack DGS-3420 Series - Page 909

xStack® DGS-3420 Series Layer 2 Managed Stackable Gigabit Switch CLI Reference Guide
904
Example
To map a VLAN ID to an MSTP instance:
DGS-3420-28SC:admin#config stp instance_id 2 add_vlan 1
Command: config stp instance_id 2 add_vlan 1
Success.
DGS-3420-28SC:admin#
To remove a VLAN ID from an MSTP instance:
DGS-3420-28SC:admin#config stp instance_id 2 remove_vlan 2
Command: config stp instance_id 2 remove_vlan 2
Success.
DGS-3420-28SC:admin#
16-8 config stp mst_config_id
Description
This command is used to configure a configuration name or revision level in the MST configuration
identification. The default configuration name is the MAC address of the bridge.
Format
config stp mst_config_id {revision_level <int 0-65535> | name <string>} (1)
Parameters
revision_level - Specify the revision level.
<int 0-65535> - Specify the revision level.
name - Specify the name given for a specified MST region.
<string> - Specify the name given for a specified MST region.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To change the name and revision level of the MST configuration identification:
DGS-3420-28SC:admin#config stp mst_config_id revision_level 1 name R&D_BlockG
Commands: config stp mst_config_id revision_level 1 name R&D_BlockG